Description
Prusa slicer
So adding -run 1 while having fuzzy skin disabled in normal prusa settings results in fuzzy skin only on top surfaces. This is actually great as I didn't want the fuzzy skin on the perimeters so I consider this to be a feature not a bug.
Speed setting isn't intuitive. When printing fuzzy skin at "180mm/s" it is much much much slower. I'm assuming the z movement is being added to the speed calculation instead of just x/y? Further using mm/min for -fuzzySpeed is weird, can it be switched to mm/s?
Speed seems to be limited by volumetric flow speed incorrectly. I have volumetric flow speed limited to 20mm3/s in my filament settings (which I don't want to change). No matter what speeds I put in Top Solid Infill and/or -fuzzySpeed the speed is limited to 180mm/s (which is slow as noted perviously). For example Top Solid Infill - 300 mm/s and -fuzzySpeed 18000 mm/min results in 180mm/s. If it was actually be limited by my volumetric flow speed it would be fine, but at "180mm/s" printing the fuzzy skin the flow rate is actually 0-2 mm3/s.
Overall really cool hope you keep developing thanks!