Generating Partial Schematics with show Command

[mmxsrup]

I would like to generate a partial schematic that includes only a subset of cells from a very large module. When I use the show command in Yosys, it creates a full schematic, which is quite large. Is there a way to limit the schematic to only show certain cells within the module? Any advice on how to achieve this would be greatly appreciated.

[jix]

The show command (among many other commands) supports selections for this use case. The manual chapter on selections has an introduction and some examples and the command reference entry for the select command is the reference for the selection syntax.

[mmxsrup]

The select command appears to be very feature-rich.
Thank you.