Test of OpenThread RCP on Nordic hardware #18
Replies: 3 comments 1 reply
|
Can not build fw for my NRF52840 (Nice! Nano v2.0) :( |
|
Anyone tested this more, I understand that it should be compatible with Nordic Semi USB adapters and development boards/kits based on nRF52 series or nRF53 series SoCs as long as build the OpenThread RCP firmware corretcly for each specific board/kit to get pin-compatibility. Like example:
also probably these less expensive USB dongles and open-source hardware;
|
|
i have explored a bit on supermicro board with nrf52 soc and it only run if i specified openthread older commit in it. Also setting up cca default mode from ED only to ED and CS and setting ED threshold can give you better stability on noisy environment (by comparing z2m maps, where coordinator arrow pointing outside to other router, 1 vs 2) |
Uh oh!
There was an error while loading. Please reload this page.
Uh oh!
There was an error while loading. Please reload this page.
Anyone willing and able to build and experiment some more, please share your findings here!
Example from OpenThread: https://github.com/openthread/ot-nrf528xx
Current reported state:
STREAM_RAWmode with Nordic firmware/hardware.Known issues:
Known limitations:
CC: @kirovilya @puddly @antst
All reactions