Leds love to be blue since LUT calibration

[chesterflaps]

As

As you can see, blue seems to be the colour I get if it's anything other than green or red.

I did the LUT calibration and HDR TO SDR is selected whilst this is doing this.

Any ideas?

[awawa-dev]

Is the current video source HDR? Take a screen shot from HyperHDR for excatly same video content as you posted with HyperHDR's HDR tone mapping enabled and disable? Check your brightness/contrast/saturation values in the logs: should be located where the grabber starts.
And do the calibration again, this time saving the HyperHDR logs as soon as it's done.

[chesterflaps]

https://www.amazon.co.uk/gp/product/B08PV2WT4S/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

this is the one I have which apparently has 4K passthrough albeit 60fps. I can live with 60fps but can you tell me if the Rullz one you mention will display 4K on my TV? Does it only make a difference to what is going into hyperhdr and the output to the tv is still 4K?

Another question regarding the calibration. You mentioned the colours were swapped. That might be to do with the fact I haven't inverted colours since I updated to V19 beta. I used to have to have it inverted before so I will try that, recalibrate and report back.

[awawa-dev]

For Rullz you need a solid HDMI splitter that will forward 4k60 HDR to the TV and 1080p60 (with washed out colors) to Rullz.

Another question regarding the calibration. You mentioned the colours were swapped. That might be to do with the fact I haven't inverted colours since I updated to V19 beta. I used to have to have it inverted before so I will try that, recalibrate and report back.

The colors were inverted in your video source that displayed the calibration board...dolby vision? But:

https://www.amazon.co.uk/gp/product/B08PV2WT4S/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

this grabber doesn't even forward HDR signal so how did you use it to calibrate HDR? It usable only with an external HDMI splitter. Please read the post on the blog where variuos grabbers where tested for HDR signal, look for Ezcoo or feintech HDMI splitter. I'm finished here.

[chesterflaps]

I also use this
https://www.amazon.co.uk/gp/product/B07VRXF4F9/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

[chesterflaps]

I'm so confused. When I use my XBSX through this setup, it says in the settings that HDR is not available on my setup yet when I check the same on my PS5, the HDR logo pops up on my TV to say it's in HDR mode and in the settings it says HDR is on.

I'd do the calibration on the PS5 if I could but there is no browser.

[chesterflaps]

Managed to work out that the XBSX needed a tick box ticking. Done that and now on with calibration but the mosaic screen is not moving