Error: USB error: Entity not found

[Censlab]

Hi,

I use wlink with a WCH-Link dongle.

wlink alone give me : <WCH-Link#0 libusb device> Bus 002 Device 009 ID 1a86:8010(USB-FS 12 Mbps) (RV mode)

but

wlink status give me : Error: USB error: Entity not found Caused by: Entity not found

I work with Windows 11 23H2

What is this Entity ?
Thanks

[kaidegit]

Try to use x86 version, or replace the WCH-Link (Interface 0)'s driver to winusb using zadig

[Censlab]

Hi Kai, This is what I did and indeed, with the Zadig driver, I immediately obtained the processor information. I think programming will work too. I will test in the next few days. THANKS De : Kai ***@***.***> À : ch32-rs/wlink ***@***.***> Sujet : Re: [ch32-rs/wlink] Error: USB error: Entity not found (Issue #57) Date : 22/03/2024 05:51:29 Europe/Paris Copie à : Censlab ***@***.***>;    Author ***@***.***> Try to use x86 version, or replace the WCH-Link (Interface 0)'s driver to winusb using zadig — Reply to this email directly, view it on GitHub, or unsubscribe. You are receiving this because you authored the thread.Message ID: ***@***.***>

[halfTree-dev]

I've met the same question on my Windows PC, and using x86 version works, Thanks.

[tietang]

Try to use x86 version, or replace the WCH-Link (Interface 0)'s driver to winusb using zadig

WIndows 11 , It's works!
Awesome, bro!

[NJCBY]

遇到同样问题，驱动换成Winusb后，官方的下载器就识别不到link了。

[furrycoding]

Should probably put this WinUSB driver replacement step into the README