Passing the flash_mode to EspruinoTools in NodeJs

[espruino-discuss]

Posted at 2022-03-11 by user141395

Dear,
I started with Espruino a couple of days ago, and I must admit it is a very fascinating technology!

Hopefully this question is in the correct category...

Via the python tool, it is possible to pass all kind of parameters:

/path/to/esptool/esptool.py --port /dev/ttyUSB0 --baud 115200 \
  write_flash --flash_freq 80m --flash_mode qio --flash_size 32m 

I was wondering if it is also possible to pass somehow these parameters (e.g. flash_mode) to the flash function of the EspruinoTools in NodeJs?

Thought that this perhaps should be specified in the Espruino.Config, but I don't think that any of those parameters can be used for this:

BAUD_RATE: 9600
BLUETOOTH_LOW_ENERGY: false
BOARD_JSON_URL: "http://www.espruino.com/json"
COMPILATION: true
COMPILATION_URL: "https://www.espruino.com/service/compiler"
ENV_ON_CONNECT: true
LOAD_STORAGE_FILE: 2
MINIFICATION_LEVEL: ""
MINIFICATION_Mangle: true
MODULE_AS_FUNCTION: true
MODULE_EXTENSIONS: ".min.js|.js"
MODULE_MINIFICATION_LEVEL: "ESPRIMA"
MODULE_PROXY_ENABLED: false
MODULE_PROXY_PORT: ""
MODULE_PROXY_URL: ""
MODULE_URL: "https://www.espruino.com/modules"
PRETOKENISE: false
RESET_BEFORE_SEND: true
SAVE_ON_SEND: 0
SAVE_STORAGE_FILE: "myapp"
SERIAL_AUDIO: "0"
SERIAL_FLOW_CONTROL: true
SERIAL_IGNORE: "/dev/ttyS*|/dev/*.SOC|/dev/*.MALS"
SERIAL_THROTTLE_SEND: false
SET_TIME_ON_WRITE: true
STORE_LINE_NUMBERS: true
WEB_BLUETOOTH: true
WEB_SERIAL: true

Hopefully somebody can give me the golden tip ;-)

Thanks!!!
Bart

[espruino-discuss]

Posted at 2022-03-15 by @gfwilliams

Hi, I don't think EspruinoTools supports uploading new Espruino firmware to ESP32/ESP8266. The -f command is for uploading to STM32-based Official Espruino boards

---

Posted at 2022-03-16 by user141395

@gfwilliams,
Ok no problem. Thanks for your feedback!!
Bart