Mapping of bores?

[peterson-tim-j]

HydroSight requires the input of projected coordinate data. It would be nice if this data was used to map the following:

Location of observation bores and pumps when selecting a bore ID
Location of pumps when selecting input forcing data for a model
Simulation results (eg drawdown) at each time step. Note, eventually this would allow mapping of the drawdown cones over time!

Doing this mapping would however require the user to input projection information for the coordinates (ie go from projected coordinate to lat/long). This additional input should be optional.

Would this be a valuable improvement? Any thoughts on this are welcome.