PSRAM Woes

[mggates39]

I have the PCB Version 3.4.3 / September 2019 board. I was building it and all the tests were passing, I was able to connect via wifi and everything. I have the SMD components, all the LEDs, resistors, capacitors, sockets and the reset switch installed. Then I messed up. I slotted the Esp32 in one pin off and sent 5 volts down the 3.5 volt rail. This blew the PSRAM, so I ordered a replacement. However, being new to SMD, I botched the hot air removal and lifted a trace. I need to know where it went so I can repair it with bodge wires.

Is there any way I can see the schematics for this board?

[mggates39]

I took the board to a local retro-computer festival and found someone with better eyes than I have to figure out where everything went. They set in some fly-wires to patch the PSRAM in and everything works great now.